Replace cpu mac pro 2010


  1. MP All Models - Mac Pro CPU Compatibility List | MacRumors Forums
  2. Faster processors with more cores can breath new life into a Mac Pro
  3. Applicable models
  4. CPU upgrade for Mac Pro 5,1

MP All Models - Mac Pro CPU Compatibility List | MacRumors Forums

Mac Pro Mid and earlier : How to remove or install memory Learn how to remove memory from or install memory into your Mac Pro computer Mid and Earlier. Click More Info. Select Hardware from the Contents list. Find "Number of Processors" under Hardware Overview. Removing or installing memory. Wait 5 to 10 minutes to allow the internal components of your Mac Pro to cool. Touch the metal on the outside of your Mac Pro to discharge any static electricity. Unplug all the cables and the power cord from your Mac Pro.

Hold the side panel and lift the latch on the back. Remove the side panel by pulling the top away from your Mac Pro and lifting up.

Faster processors with more cores can breath new life into a Mac Pro

Pull the latches until they open all the way and release the processor tray. Remove the processor tray and lay it on a soft, clean cloth on the desk or work surface, to protect the tray and avoid scratching the work surface. Hold the side panel against your Mac Pro and push the latch down to secure the side panel. You can attach a lock or cable through the metal loop to secure your Mac Pro. Flip the lock tab down before you close the latch. Removing or installing memory Warning: Let your Mac Pro cool down for 5 to 10 minutes before you touch the internal components.

Step 1: Remove the side panel Shut down your Mac Pro. Step 2: Install or remove the memory cards Using the two finger holes, pull on the memory cards to remove them, then place them on a soft, clean cloth with the DIMMs facing up. Step 3: Replace the side panel Stand your Mac Pro up and replace the side panel.

Mac Pro Repair - Fans, Heat Sink and Processor Removal

Learn more. Checking that your computer recognizes the new memory Press the power button to turn on your Mac Pro.

  • Upgrading a Mac Pro to More Cores or Faster CPU?
  • You might also likeā€¦!
  • Mac Pro (Mid 2012 and earlier): How to remove or install memory?
  • dlink easy search for mac.
  • Navigation menu.
  • transfer songs ipod to itunes mac?
  • active client for mac download.

Yes No. Just be careful not to overuse the rubbing alcohol and have some spill over onto other parts of the system. With the parts cleaned, I opened the package containing the new processors and the first thing I took note of was the drastic difference in appearance between the chips.

The stock chips used on the 8-core Mac Pro are lidless, meaning the metal cap used for protection that is recognizable on most chips is not present and the core of the chip is directly exposed. I feared this may cause two issues: first, because the chips I was installing were lidded, the extra height of the lid might not allow the heatsink and CPU to sit properly in the socket; second, the Mac Pro was thermally designed for lidless chips and the lidded chips might cause temperatures to rise too high.

Both concerns proved to be immaterial in the end, although special consideration had to be paid to ensure that this was the case. I then began to slowly tighten the hex screws that hold the heatsink in place. Because the new CPU was slightly thicker than the old one due to its lid, I wanted to tighten the screws a little at a time until I was sure that the heatsink was tight and secure, but not so tight as to cause damage to the socket. The 8-core Mac Pro can run with just a single processor installed, so I quickly put the computer back together to test my installation before attempting to replace the second CPU.

To my relief, the system booted up just fine and System Profiler showed that a single 3. Satisfied, I shut down and dismantled the computer again to install the second CPU, repeating the steps above. I was quite concerned that I had damaged something and began fearing for the worst: a lifetime of listening to a jet engine under my desk those with Mac Pros know just how loud our machines can get when the fans go full speed.

Applicable models

I shut down and disassembled the system again. I decided to try removing and reattaching the second heatsink in hopes that it would solve the issue. Starting with version 2. I let that test run for several hours and thankfully received no errors.

CPU upgrade for Mac Pro 5,1

Turning again to the aforementioned GeekBench, I ran the test three times and averaged my results. Before the upgrades, my GeekBench Score was a respectable By contrast, a top-of-the-line Mid core Mac Pro at 2. The performance increase has been noticeable in everything from day-to-day usage to Final Cut Pro X rendering.